...
In the Query Field, select which attribute you would like to query against.
Select the Condition of the query. These conditions may vary or even be removed depending on the Query Field selected.
In: Select from a group and include in the rule
Not In: Select from a group and exclude from the rule
=: Query against an individual ID.
<>: Query against all except an individual ID.
Like: Query against a portion of an ID
Not Like: query against all IDs that do not satisfy the portion of of the ID
Enter the Value of the query.
In or Not In: Click on the browse icon to bring up a list of available values. Select from the list and click OK.
= or <>: Enter the specific ID
Like or Not Like: Enter a portion of the ID using the '*' as a wild card.
Click the Apply button.
Repeat until all applicable queries are added.
If the rue is modified in anyway, you must Publish the matching rule again by clicking the corresponding Publishlink. This verifies that the query is valid. If a policy is not published, it will not be used in the validation process, even if it is active. |